Aqua One AquaStyle 620 Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Засіб для догляду за домашніми тваринами Aqua One AquaStyle 620. Aqua One AquaStyle 620 12 сторінок.
Також для Aqua One AquaStyle 620: Посібник із швидкого старту (2 сторінок)

Друкувати сторінку

Filter Maintenance

WEEKLY

1. Turn the power head off.

2. Open the lid from the filter unit.

3. Remove the elbow and spray bar unit from the

top of the power head.

4. Remove the carbon cartridge and black filter

sponge from the filter unit.

5. Empty a small amount of water from the

aquarium into a bucket.

6. Rinse the black filter sponge in the bucket.

Discard the used water; do not add it back into the

aquarium.

7. Rinse the carbon cartridge out under the tap,

rinse thoroughly.

8. Reinsert the black filter sponge and carbon

cartridge.

9. Then connect the elbow and spray bar unit back

onto the outlet at the top of the power head. Make

sure the holes of the spray bar are pointing down

onto the carbon cartridge and that the end of the

spray bar has the cap fitted.

10. Ensure the aquarium is full. (Refer to page 6).

11. Turn the power head back on and ensure that

water is flowing out of the spray bar.

12. Replace the lid on the filter unit.

13. Add a filter supplement such as Aqua One Bio

Starter.

The

carbon

filter

replaced every 6 - 8 weeks for optimum filter

performance.

MONTHLY .

1. Turn the power off. Unplug both power leads.

2. Remove the light unit and place it somewhere

safe away from water and where it will not be

broken / damaged.

3. Remove filter unit from aquarium, take to sink

and open the lid.

4. Disconnect spray bar and elbow and clean with

an Aqua One double ended pipe brush.

5. Twist the power head 90º to remove from

filter unit.

6. Pull impeller cap off bottom of power head, this

will uncover the impeller.

7. Grasp the impeller blades and remove from the

impeller chamber.

8. Use an Aqua One double ended pipe brush to

clean impeller and inside of impeller chamber.

9. Also run a pipe brush through the outlet at the

cartridge

should

top of the power head.

10. Clean the intake pipe and strainer thoroughly.

11. Reconnect all parts and place filter unit back

onto the aquarium.

12. Ensure the power lead is not wet and plug it

back in.

13. Turn the power back on and check that water

is flowing though the spray bar.

14. Replace the light unit.

YEARLY

The ceramic noodles are designed to be

maintenance free, NEVER RINSE THEM IN TAP

WATER.

See Hints & Tips for Best Results for more

information.

Powerhead Diagram

Impeller Chamber

Power Head

Impeller

Impeller Blades

Impeller Cap

Outlet