Avonic AV-CON300 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Контролер Avonic AV-CON300. Avonic AV-CON300 13 сторінок. Ptz camera controller
Також для Avonic AV-CON300: Посібник користувача (16 сторінок), Посібник із швидкого старту (2 сторінок)

Друкувати сторінку

2. camera baud rate setting, the baud rate of the 5 cameras, each address baud rate is not the

same. Method: use the keyboard CAMERA to select the area key to select the camera address

code, CAM1 to CAM5. D control lever up and down - select baud rate

3. keyboard joystick control left and right reverse switch settings. Methods: three dimensional

control rod up and down - select the joystick to control the reverse on / off.

4. keyboard screen standby time. Methods: Joystick up down---Select the keyboard screen

lighting time

5. button beep switch, Methods: Joystick rod up and down --select the keyboard button beep on

/ off.

6. keyboard menu to enter the password switch. Methods: three dimensional control rod up and

down - select the keyboard menu to enter the password on / off

7. keyboard menu password settings. Methods: using the "POSITION" area of the 1-10 button

(10 button keyboard password is calculated as 0)

8. keyboard menu reset. Methods: three dimensional control lever up and down - choose

whether to reset the keyboard menu

Operation

1. Boot

Plug in the keyboard power supply, monitor will display the default number CAM 1.

2. Select the machine number

Press the keyboard interface CAMERA area digital (1-5) key to control the machine number, for

example: by the number "3" key, the display:

After determining the number, all operations are performed on this camera.

3. Control joystick operation

In the lower right corner of the control rocker is the rapid rotation of the camera and the lens of the

control components, there are left and right, up and down rotation of three-dimensional control

function. The left side of the camera is rotated to the left of the camera, the rocker is upward, and

the camera rotates upwards, and the rotation speed of the pan head is adjusted by a "PTZ/ZOOM

SPEED" knob. The ZOOM knob can control the telescopic lens of the camera and watch the close

range of the vision.

4. Preset settings

The preset position is a kind of operation that the front desk staff will advance the camera lens to the

speaker's position. After setting the preset position, the conference call only the preset number, the

camera can quickly turn to determine the location. This machine can be preset 10. Operation as

follows:

First, the operation of the joystick to make the lens aligned with the desired position, press the

"PRESET" button (set the preset "PRESET" button will remain in a state of light), display:

Select the "POSITION" area number key (1-10) to enter the preset number 1, that is, the completion

of the preset number 1 settings, display:

Again operate the joystick to second points, followed by the operation of the input of a different

number, pay attention to the operator should remember the location and number of speakers.