CP Electronics EBDHS-B01-DD Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з монтажу для Аксесуари CP Electronics EBDHS-B01-DD. CP Electronics EBDHS-B01-DD 12 сторінок. High bay sensor (for integration)
Друкувати сторінку
UNLCDHS Programming – LUX Control
Basic Parameters for EBDHS-B01-DD
Parameter
Default
Light Level (MI)
999
LUX Learn Level
Auto Brightness
%
LUX On Level
999
LUX Off Level
999
LUX On Time
LUX Off Time
UNLCDHS Programming – Configuration
Basic Parameters for EBDHS-B01-DD
Parameter
Default
Factory Reset
Soft Reset
IR Enabled
Yes
Range / Option
1 – 950
(999 = maintained
illuminance off)
0
0 – 950
0
0 – 100 (0 = disabled)
1 – 950,
999=disabled
1 – 950,
999=disabled
0
0 – 99 minutes
0
0 – 99 minutes
Range / Option
–
–
–
–
Yes / No
Sets a target light level to be maintained by the lighting system.
Limit the target LUX setting to within 950 LUX which when mounted on the
ceiling would equate to around 1900LUX on desk level for a reflectance factor
situation of 0.5.
Use with the Readback function to get the LUX level the unit is currently
reading. Press Send to update the Light Level (MI) parameter with this value.
Instead of setting LUX ON and OFF as individual parameters, Auto brightness
sets these parameters as the assigned percentage of Light Level (MI)
parameter value. This is the % amount above the Light Level (MI) parameter
value being used to set as the LUX OFF value. LUX ON will always be set fixed at
10% below the target Light Level (MI) parameter when this function is utilized.
Sets the light level below which will turn on the output in conjunction with
movement control. The output will turn on without movement should the
Disable Detect parameter be set to YES.
999 disables both LUX ON and LUX OFF functions.
The LUX Off Level value must always be greater than the LUX On Level value.
Sets the light level above which will turn OFF the output in conjunction with
movement control.
999 disables both LUX ON and LUX OFF functions.
The LUX Off Level value must always be greater than the LUX On Level value.
When the ambient light falls below LUX ON Level, the time to wait before
switching on the lights. If at any time during the timed delay the LUX change
reverses then the process is cancelled. Minimum time of around 15 seconds
is set for a value of 0.
If you try to turn lights on using a switch or handset, the lights will go on
regardless of ambient light level. However, if there is sufficient ambient light,
they will turn off again after LUX Off Time.
When the ambient light rises above LUX OFF Level, the time to wait before
switching off the lights. If at any time during the timed delay the LUX change
reverses then the process is cancelled. Minimum time of around 15 seconds
is set for a value of 0.
Clears any programmed settings and returns the device to its default set-up.
Reboots the device, but retains all current settings. Must leave value at zero.
Set to No to prevent the device from receiving commands from the handset.
The device's LED will flash several times if you try to send a command when in
this state. Set to Yes to re enable programming.
Description
Description
7