Allied Systems Long Reach BHA Series Посібник з монтажу, технічного та сервісного обслуговування - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник з монтажу, технічного та сервісного обслуговування для Підйомні системи Allied Systems Long Reach BHA Series. Allied Systems Long Reach BHA Series 20 сторінок. Billet handler
Друкувати сторінкуInspect the cylinder rod for:
1. Scratches or nicks on the rod surface.
2. Straightness of the rod.
3. Damaged threads.
Inspect the gland cap for:
1. Scratches or nicks in seal grooves.
2. Damaged threads or spanner wrench holes.
3. Excessive wear in bore.
Replace any component found to be defective.
5.6 Cylinder Assembly
1. Spray the piston, gland cap, and seals with wd40 or
other similar product to ease slipping of the seals in
place.
2. Note the direction of the seal on the piston. Improper
installation will result in poor performance. The cupped
side or O-ring side of the seal should be facing the
gland cap. (Figure 5-6)
Wear Band
Piston Follower
Piston Nut
Cylinder Rod
Figure 5-6, Piston Seal
3. Install the seals and wipers in the gland cap. Note the
direction of the seals. The cupped side or O-ring side of
the seal should be facing the piston. (Figure 5-7)
18
Seal
4. Install the gland cap on the cylinder rod being ex-
Piston
tremely careful not to cut the rod seal on the threads
of the rod or rod shoulder. If available, use a sleeve or
plastic electrical tape to cover the rod threads.
O-Ring
5. Install the piston on the rod and tighten the locknut to
90 ft-lbs (0.56 UNF), 22 ft-lbs (0.75 UNF).
6. Spray the inside of the cylinder tube with lubricant to
ease inserting the rod and piston. Insert the rod and
piston into the cylinder tube. Tap the rod in with a rub-
ber mallet if resistance is encountered.
7. Tighten the gland cap using a spanner wrench.
Backup Ring
O-Ring
Retaining Ring
Seal
A
DETAIL A
Gland Cap
Figure 5-7, Gland Cap Seal
Bushing
Wiper Ring
Cylinder Rod
45-053, REV. 5/18