Allied Telesis AT-8600 Series Примітка до випуску - Сторінка 3
Переглянути онлайн або завантажити pdf Примітка до випуску для Перемикач Allied Telesis AT-8600 Series. Allied Telesis AT-8600 Series 6 сторінок. Virtual chassis stacking
Також для Allied Telesis AT-8600 Series: Усунення несправностей (5 сторінок), Брошура (12 сторінок), Як налаштувати (9 сторінок), Брошура (8 сторінок)
Друкувати сторінку
Patch sr264-03 for AT-8600 series switches
Patch sr264-03 for Software Release 2.6.4
C613-10407-00 REV C
PCR: 40417
Module: OSPF
When LS Acks (Link State Advert acks) were received, they were compared
against the transmitted LSA (Link State Advert). If it was the same, the LSA
was removed from the re-transmission list. The algorithm used in this check
has been changed to be compliant with the algorithm specified in section
13.1 of RFC2328, to determine if the LS Ack received is the instance as the
LSA.
PCR: 40440
Module: CLASSIFIER
For those classifiers that specified the IP protocol as a match criterion, the IP
protocol number was being stored and displayed in a configuration file as a
hexadecimal value rather than a decimal value. This issue has been
resolved.
PCR: 40441
Module: IPG, VRRP
If VRRP was enabled and a reset ip command was issued followed by a
disable vrrp command, then the device would still reply to pings, even
though the device was no longer the VRRP master. Duplicate echo replies
were seen on the device sending the pings. This issue has been resolved.
PCR: 40446
Module: DHCP
In certain situations, if a DHCP client used a DHCP relay agent to request
IP addresses from the switch acting as the DHCP server on a different
subnet, it was not be able to renew the IP address allocated to it. This issue
has been resolved.
PCR: 40447
Module: CORE, SWI, SW56
Support was added for new fibre uplink modules A45SC, A45SCSM, and
GBIC uplink module A47.
PCR: 40453
Module: IPG
Particular IP packets (unicast destination IP, but multicast destination
MAC) could result in a memory leak, which in some cases could cause the
device to stop responding to the command line. This issue has been
resolved.
3
Level: 3
Level: 3
Level: 4
Level: 2
Level: 2