AVPro Edge AC-MXNET-10G-SW24Q Посібник із швидкого старту - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання AVPro Edge AC-MXNET-10G-SW24Q. AVPro Edge AC-MXNET-10G-SW24Q 8 сторінок. The mxnet 10g sdvoe ecosystem
Auto-Matrix
- SWITCHING
From here, users can switch between sources and displays, just like with an HDMI matrix switcher.
The sources are located on the left, and the displays are on the right. Simply click on a source,
then click the display it is to be viewed on. Matrix presets can also be saved and recalled on this
page for faster switching.
Troubleshooting
Transceiver or CBox not powering on:
network switch and check the LED indicator lights for each device connection. If only one device isn't
getting power, verify the connection to the network switch is correct (see examples below).
Verify Connections (device not getting power, video signal dropouts, Mentor shows device with poor connection, etc.):
Check that all cables are properly connected and not tightly bundled together or exceeding their bend
radius.
•
For Category cabling, re-terminate using standard RJ-45 connectors. Avoid using push-through or
"EZ" type ends, as these have exposed copper wiring at the tips that can damage or bend the pins
inside the ports.
•
For optical fiber cabling, try re-terminating fiber connection ends to eliminate potential issues.
•
Ensure the SFP+ modules are specifically designed to output 10Gb/s and are properly seated
within the SFP+ port on both the network switch and MXNet 10G device.
•
Generally speaking, the higher the video resolution and the longer the cable run, the better the
cabling should be. For most copper installations, Cat6a (or better) is recommended with MXNet.
If all devices are not getting power, verify the power connection on the
Page 7 of 8
MXNET 10G SDVoE
®
Quick Start Guide