Aqua PRO SINGLE SPEED Швидкий старт Quide - Сторінка 5
Переглянути онлайн або завантажити pdf Швидкий старт Quide для Насос для басейну Aqua PRO SINGLE SPEED. Aqua PRO SINGLE SPEED 8 сторінок. Owner’s manual installation, operation & parts
Друкувати сторінку
A Ground Fault Circuit Interrupter (GFCI) is required in the circuit. For size of GFCI required and test procedures for
GFCI, please see manufacturer's instructions.
OPERATION
Avoid running the pump dry. Fill the pump with water before starting motor. Before removing the trap
cover:
1. STOP PUMP before proceeding.
2. CLOSE GATE VALVES in suction and discharge pipes.
3. RELEASE ALL PRESSURE from pump and piping system.
4. NEVER tighten or loosen clamp while pump is operating!
If pump is being pressure tested, be sure pressure has been released before removing trap cover. Do not
block pump suction. To do so with body may cause severe or fatal injury. Small children using pool must
ALWAYS have close adult supervision.
Fire and burn hazard. Motor runs at high temperatures, to reduce the risk of fire, do not allow debris, or foreign
matter to collect around the pump motor. Allow the motor to cool prior to handling or performing maintenance.
The motor is equipped with an internal thermal protection circuit to guard against overheating. The maximum
ambient temperature for the motor operation must not exceed rating on motor model plate.
Priming Pump
Release all pressure from filter, pump, and piping system; see the filter owner's manual. In a flooded suction system
(water source higher than pump), pump will prime automatically during suction and discharge valves are opened. If
the pump is located above the normal pool water level, remove ring and cover assembly, and fill basket and pump
with water. Clean and inspect o-ring; then reinstall on trap. Replace ring and cover assembly, then rotate clockwise
to tighten cover.
NOTICE: Tighten ring and cover assembly by hand - do not use tools. Pump priming time will depend on the vertical
distance and length of the suction line. The pump is designed to prime at 10 ft or less. If the pump does not prime,
make sure that all valves are open, and that the suction pipe is submerged. Verify there are no leaks in the suction
lines.
Routine Maintenance
The only routine maintenance needed is the inspection and cleaning of the trap basket. Debris or trash that collects
in the basket will choke off water flow through the pump.
Before attempting to clean the basket:
A. Stop pump, close valves in suction and discharge, and release pressure from system.
Hazardous suction can trap hair or body parts, causing severe injury or death. Do not block suction.
B. Remove the ring and cover assembly by turning counterclockwise. If necessary, tap handles gently with a rubber
mallet.
C. Remove the basket and clean. Inspect holes in basket for blockage. Clean the basket with water and replace in
trap. Verify that the basket is oriented correctly in pump housing.
D. Clean and inspect lid o-ring; then reinstall the ring and cover assembly.
5
-
-