AVProConnect AC-EX70-UHD Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Подовжувач AVProConnect AC-EX70-UHD. AVProConnect AC-EX70-UHD 16 сторінок. 4k hdmi 2.0 extender with hdcp 2.2
Також для AVProConnect AC-EX70-UHD: Посібник користувача (12 сторінок), Посібник користувача (12 сторінок)

Друкувати сторінку

AC-EX70-UHD-KIT

Indicator Troubleshooting Lights on the Receiver (cont.)

LINK - Above RJ45 (HDBT) Port:

between the Transmitter and Receiver is intact. This light will ALWAYS be solid. If this

light is flashing or not present do the following:

1. Check the length. The maximum distances are 40m (131ft) on 4K and 70m (230ft)

on 1080P.

2. Remove any coils of cable and make sure that there is not excess cabling.

3. Bypass all patch panels and punch-down blocks.

4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is

valid, something may be slightly off.

5. Contact AVProConnect if these suggestions do not work.

STATUS- Above RJ45 (HDBT) Port:

present between the Transmitter and Receiver. This light ALWAYS BLINKS steadily

indicating everything is correct. If you do not see this light, try the following:

1. Check the length. The maximum distances are 40m (131ft) on 4K and 70m (230ft)

on 1080P.

2. Remove any coils of cable and make sure that there is not excess cabling.

3. Bypass all patch panels and punch-down blocks.

4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is

valid, something may be slightly off.

5. Try Powering from the Receiver instead of the Transmitter (See Receiver page for

more about PoE direction).

6. Contact AVProConnect if these suggestions do not work.

Powering the system:

Bi-Directional Power - The AC-EX70-UHD-KIT allows you to choose where you power

the system. You have to power options:

•

From the HDBaseT Tx - In this mode power will be supplied to the Rx through the

CAT cable.

•

From the HDBaseT Rx - In this mode power will be supplied to the Tx through the

CAT Cable (This is known as "Reverse Power)

NOTE: There is no

button or switch to

set the mode -

Simply plug the

power supply into

the Tx or Rx and the system

know what to do.

(Green)

This indicator shows that the AV HDBT link

(Amber)

This indicator shows that the power is

will electronically