CPAT FLEX IRX1 Посібник з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Приймач CPAT FLEX IRX1. CPAT FLEX IRX1 13 сторінок.

Друкувати сторінку

3.3 Electrical Installation

The AC/DC adapter is supplied with the equipment. It is compatible with 110V/220V voltages

and 50/60 Hz power distribution networks.

3.4 Internet Connection

The IRX1- needs an access to the internet to transmit received measurement level to the

CPAT servers and for automatic firmware update. Transfers vary from less than a 1MBytes to

a maximum of ~7Mbytes per day depending of the intensity of the patrolling, the number of

ITX1 in the sector and the number of failure on the network.

The IPv4 address is acquired with the use of DHCP. If no DHCP server is present on the

network, the system will not be able to transmit data over the network.

Make sure that the unit has an access to the Internet and that the FTP port 21 is open.

Without this access, it won't be able to communicate with our FTP and "Realtime Ingress

Monitor" servers (RIM).

NOTE

It is recommended that you install the IRX1 behind a firewall, or a router with an

integrated firewall, to avoid malicious or unauthorized connections (Ref:

www.kb.cert.org/vuls/id/107886).

4. Setup

Make sure that the unit has an access to the Internet and that the FTP TCP port 21, remote

assistance TCP port 26 and RIM UDP port 20000 is open (outgoing). Without those rules, it

won't be able to communicate with our FTP and "Realtime Ingress Monitor" servers (RIM)

and we won't be able to access the IRX1 for remote assistance.

If you want to combine nodes on the same RF entry, be aware that the IRX1 sensitivity

performance might be affected: since the IRX1 tries to detect ingress, the incoming digital

ingress signal is not always at the same level. Also, the measured value does not take into

account the pads.

5. System Operation

5.1 Power On

To power on the unit, make sure that the power cable is properly connected to a power bar

(recommended) and into the IRX1- then press the ON/OFF button on the front panel for 3

seconds then release it. You should see both lights on the front panel turn green then the

http://

PWR-light will turns red.

5.2 LED and LCD Information

The two front LEDs indicates the status of the unit.

PWR (power):

DIAG (diagnostic):

The LCD let the user know information about the unit.

Line 1: indicates the highest ingress measured value in the last second and the associated

CPAT FLEX (IRX1)

Operation Manual

• When RED solid, the system is booting (takes about 1 minute to boot).

• When GREEN solid, the system is powered up and booted.

• When OFF, the system is working fine.

• When flashing GREEN, an ingress fault has been detected.

• When flashing RED, an error has occurred.

RF port.

effigis.com