AVS RM43B-DVR Посібник з інсталяції
Переглянути онлайн або завантажити pdf Посібник з інсталяції для Автомобільні аксесуари AVS RM43B-DVR. AVS RM43B-DVR 5 сторінок. Oem replacement mirror monitor with dvr
Також для AVS RM43B-DVR: Посібник користувача (9 сторінок)
Друкувати сторінку
Thank you for choosing the AVS range of LCD monitors. Please ensure installation is carried out by a suitably qualified technician using
industry best practice. All connections to 12/24v should be appropriately fused.
IMPORTANT: Where wiring diagram shows an ACC connection the wire MUST be connected to ACC DO NOT connect to ignition or
constant 12v.
AVS RM43
WIRE COLOUR
FUNCTION
RED (ACC)
+12v ACC supply
BLACK
Earth
YELLOW RCA
AV2 camera input
WHITE RCA
AV1 camera input
REAR BUTTON
FUNCTION
TOP
Adjust display brightness/contrast up
MIDDLE
MENU – push to enter menu and scroll through functions
BOTTOM
Adjust display brightness/contrast display brightness/contrast down
AVS RM50SM
WIRE COLOUR
FUNCTION
RED (ACC)
+12v ACC supply
BLACK
Earth
PURPLE
Switches to IN2 input
when 12v applied.
Switches off or back
to IN1 (if signal
present on IN1) when
12v removed.
IN1
Video input
Displays input when
video signal is
detected
IN2
Video input
controlled by purple
wire
REAR BUTTON
FUNCTION
TOP
Adjust display brightness/colour up
MIDDLE
MENU – push to enter menu and scroll through functions
BOTTOM
Adjust display brightness/ colour display brightness/contrast down
AVS RM50SM WIRING DIAGRAM
AVS RM SERIES LCD MONITORS – INSTALL GUIDE
AUGUST 2017
CONNECT TO
Appropriately fused +12v switched ACC supply
Good earth source e.g. vehicle body/chassis
Reverse camera output. Monitor will auto switch to display this input when a signal is
detected e.g. when the car goes into reverse and powers on the camera. The display will
switch back to AV1 or turn off if there is no signal on AV1.
Camera output. Monitor will display AV1 until a signal is detected on AV2.
CONNECT TO
Appropriately fused +12v switched ACC supply
Good earth source e.g. vehicle body/chassis
Connect to 12v switching output eg reverse light.
Connect to switched video source eg reverse camera.
Connect to video source. Monitor will display video when a 12v signal is detected on
purple wire.