AVS 5000i Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Автосигналізація AVS 5000i. AVS 5000i 10 сторінок.

It is wise to replace the remote batteries before they fail

completely. An indication that the batteries need replacing is a

reduction in the operating range. When the batteries in the

remote are almost flat the remote's LED will flash instead of

lighting constantly when a button is pressed.

Normal operation

Auto immobilisation

The AVS 5000i will automatically immobilise 38 seconds after the ignition is

switched off. The LED will flash once the car is auto-immobilised. The

immobilisers must be disarmed before the vehicle can be started.

Arming the system

To arm the system turn off the ignition, exit the vehicle and ensure all

doors (and bonnet/boot/hatch) are properly closed then press the top

button on your remote.

The indicator lights will flash once and siren will also chirp once. If the

system is connected to your central door locking the doors will lock at this

point. The LED light on the dash will stay on for 20 seconds then flash. The

system will not activate until the LED on the dash starts flashing.

This procedure will also arm the alarm if the system has entered auto-

immobilise mode.

Error zone report

If any of the zones (door/bonnet/boot/hatch) are open when you arm the

alarm the system will warn you by chirping after four seconds. The system

will still arm, but will exclude the open zone until it is properly closed. See

the table below for zone codes.

Number of chirps

* If your vehicle has a factory interior light delay this feature may not be available.

Error zone

Door*

Bonnet/boot

Shock sensor

Ignition

Voltage drop

Optional sensor