AVS RXPRO Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автосигналізація AVS RXPRO. AVS RXPRO 10 сторінок. 4-channel controller

ADDING NEW REMOTES (Up to a maximum of 5 remotes)

Enter programming mode (see above).

DELETING REMOTE CONTROLS

If a remote is lost or stolen, you can simply erase the lost/stolen remotes by repeating the procedure above 6 times. This

will fill the system memory with remotes that only you have in your possession.

Note: For latched output you must turn off TIMED OUTPUT first (see page 5)

Press button 3 repeatedly until the channel lights indicate one of

the output channels you wish to program. Select a channel that

you wish to operate with a remote control i.e. not a channel that

you wish to operate with a wireless detector.

Press button 2 until the feature lights are on as shown.

Press button 1 to set the feature light(s) to flashing.

NOTE: By default the feature light(s) will be flashing, if not press

button 1 to set to flashing.

Press button 2 repeatedly until the feature lights are off as

shown.

Press and hold button 1 until the channel lights(s) begin to flash.

Immediately press button 1 repeatedly on the new remote

control you wish to learn in until the channel light(s) stop

flashing.

Press and hold button 2 on the new remote control until the

lights start scrolling.

The new remote control has now been learnt in.

Page 4