CPG 351FFOP40L Посібник з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Фритюрниця CPG 351FFOP40L. CPG 351FFOP40L 13 сторінок. Open pot fryers
Також для CPG 351FFOP40L: Посібник користувача (16 сторінок)

Друкувати сторінку

Service Manual

351FFOP40N, 351FFOP50N, 351FFOP40L, 351FFOP50L

HIGH LIMIT THERMOSTAT (450°F)

Follow pre-maintenance steps on page 4

Remove 2 hex head screws from side of mounting

bracket, 8mm socket (Fig. 18)

Remove wiring from high limit thermostat, note

locations to move to new high limit thermostat

(Fig. 17)

Pry apart holding tongs on the bracket inside the

fryer pot holding the sensing probe. (Fig. 19)

Remove holding nut for high limit thermostat

capillary wire from underside

of fryer pot with 18mm wrench (Fig. 20)

Remove high limit thermostat capillary

wire and sensing probe from fryer pot

Installation is reverse of removal, ensure sensing

bulb is mounted in tongs before tightening

holding nut

Use thread sealant on holding nut for capillary wire

and ensure no leaks after install

THERMOPILE

Follow pre-maintenance steps on page 4

Remove wires from high limit thermostat that go

to thermopile (Fig. 17)

(White and Red color)

Remove two hex head screws that hold thermopile

bracket in place with an 8mm socket. (Fig. 23)

Remove compression nut from thermopile mount

with a 7mm wrench, do not lose compression nut

(Fig. 22)

Remove thermopile from mount by

pulling down

Slide on compression nut from old thermopile to

new thermopile

Ensure thermopile is fully seated in mounting

bracket before tightening compression nut

Installation is reverse of removal

FIG. 17

FIG. 19

FIG. 21

FIG. 23

FIG. 18

FIG. 20

FIG. 22