DFM CFB16 Посібник оператора - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник оператора для Аксесуари для тракторів DFM CFB16. DFM CFB16 20 сторінок.

t WARNING: The cutting disc is heavy. Be careful and use assistance.

DISK REMOVAL: The cutting disk can be removed by simple hand tools, and can be done in the field. Blade removal

must be done with unit off carrier.

Step 1: Disengage Hydraulics and Electronics

Disengage all hoses and electric lines (use zip tie to coil

them safely out of way)

Step 2: Place the Unit on the Ground

While the unit is attached to the carrier, roll the carrier

arms completely forward until unit is horizontal; lower

unit onto hard stable surface and disengage the

carriers lock feature. Unit is now disengaged from

carrier. Move carrier away from unit and work area.

Step 3: Remove The Bolts

Remove the 4 bolts that attach the skid plate using

an impact wrench and a ¾" socket. There are 2 more

bolts underneath the skid plate; remove these bolts.

Removing / Replacing the Blade

Step 4: Remove the Blade

Once these bolts are removed the disk can be

taken off the unit; in order to fully remove the

disk, it needs be to be slipped past the slide rails.

To do this, the disk is first pulled off the hub,

then slide all the way to the right of the deck,

At this point it's pivoted allowing the

left side of the disk to clear the rails.

To replace the disk back on the unit, repeat these steps

in reverse.

NOTE: Make sure to face the cutting edge of the teeth

towards a clockwise rotation from the bottom.

Removing / Replacing the Blade | 7