Allied Telesis Patch SB244-01 Примітка до випуску - Сторінка 3
Переглянути онлайн або завантажити pdf Примітка до випуску для Перемикач Allied Telesis Patch SB244-01. Allied Telesis Patch SB244-01 4 сторінки. Allied telesis, inc patch switch release note
Друкувати сторінку
Patch SB244-01 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches
Patch SB244-01 for Software Release 2.4.4
C613-10349-00 REV A
PCR: 02401
Module: IPV6
Neighbour discovery and PIM6 caused a fatal error when IPv6 was not
enabled, or when the IPv6 feature license was not present. This issue has
been resolved.
PCR: 02406
Module: IPV6
A Router-Alert option has been added. Also, the SHOW IPV6 MLD
INTERFACE command now works correctly.
PCR: 02407
Module: IPG
ICMP was sending too many messages back as responses to fragmented
packets. This issue has been resolved.
PCR: 02409
Module: IPG
A warning now appears when the DELETE IP INTERFACE command is
executed before the DELETE DVMRP INTERFACE command.
PCR: 02410
Module: VRRP
VRRP pre-empt mode was not working with advertisement updates of 1
second or more because this did not allow for interface start time on startup.
Now a check is made to verify that interfaces are UP before timers are
started.
PCR: 02413
Module: IPG, IPX2
Static IP ARP entries could not be added to hardware at boot time. Also, an
IPX circuit could not be deleted from hardware. These issues have been
resolved.
PCR: 02416
Module: DVMRP, IPG
Multicasting forwarding was not working correctly. This issue has been
resolved.
PCR: 02417
Module: VLAN, IPG
The IGMP port list was not updating correctly when a port went down. This
issue has been resolved.
PCR: 02418
Module: IPV6
ICMPv6 was returning an error for non-zero fragment offsets. This issue has
been resolved.
PCR: 02415
Module: IPG
Packets with a RIP source address and next hop address that are not on the
same subnet as the interface will now be processed. If the received next hop
is not on the same subnet, it is treated as 0.0.0.0.
PCR: 02420
Module: SWI
On GBICs, the link was forced up when the transmit fibre was removed.
Once up, the link could not be taken down again by removing the transmit
fibre. This issue has been resolved.
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
3