CPI GRYPHON Посібник з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Лічильники готівки та сортувальники монет CPI GRYPHON. CPI GRYPHON 5 сторінок. Coin changer
Також для CPI GRYPHON: Посібник з інсталяції (4 сторінок)
Друкувати сторінку
Cassette configuration
Two methods for configuring the coin changer cassette are outlined below.
The cassette must be empty before configuring or recalibrating.
Configuration method
Cassette code
Individual tubes or custom
cassette
Installation
To install the coin changer:
1
Remove the coin changer from packaging. If it was damaged during shipping, go to
customer service contact near you.
Review the operating voltage on the label that is displayed on the left side of the device (when looking at the front of the
coin changer).
2
Turn off power to the vending machine.
3
Lift the yellow latch on the top right of the coin changer and tilt the validator
assembly forward to access the coin changer mounting holes. The cassette
does not need to be removed.
4
Hang the coin changer on the vending machine's mounting screws, ensuring the
unit is level. See Alignment.
5
The lower mount (5a) can be difficult to see through the device. Hanging the coin
changer from the top 2 screws (5b and 5c) first will help to locate the lower
mount.
6
Tighten the mounting screws, if necessary, being careful not to over-tighten.
Close the validator assembly. The lower mount is difficult to access with a large
screwdriver.
7
Remove the cassette if coins will be directly inserted into tubes. Lift it by the
handle and pull toward you.
8
Fill the cassette with coins, ensuring coins are inserted into the proper tubes.
9
Return the filled cassette to the coin changer and ensure it is correctly seated.
10
Restore power to the vending machine.
© 2023 Crane Payment Innovations. All rights reserved.
v1.0 EN
Steps
To change the cassette:
1. Press
, followed by CASSETTE.
2. Enter the required cassette code and press SAVE.
Follow the custom cassette steps below if the code is not recognized.
3. Press START to calibrate the empty cassette when prompted.
Tubes are coin-specific. Accepted coin size is printed on the side of the tube.
To change individual tubes or create a custom cassette:
1. Press
, followed by CASSETTE.
2. Use keys A-F to select the tube position.
3. Select the denomination for the tube.
4. Press SAVE to store the setting.
5. Press
when all tubes are programmed.
6. Press START to calibrate when prompted.
CranePI.com/Support
to locate a
5b
CPI support
5c
5a
4