CPI Talos T6 Посібник з монтажу - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з монтажу для Лічильники готівки та сортувальники монет CPI Talos T6. CPI Talos T6 18 сторінок.
Також для CPI Talos T6: Посібник (2 сторінок)

Друкувати сторінку

This chapter outlines:

• How to program the note validator with the configuration coupon

•

How to enable notes and configuration coupons on the note validator

To program the note validator with the configuration coupon:

Locate the printed configuration coupon that ships with the product. To obtain an additional or replacement copy see

"Additional Helpful Documents", p. 4

instructions in the configuration coupon document to complete and prepare the configuration coupon for the steps below.

Remove the note magazine, and then use a pencil or a screwdriver

configuration button to enter configuration mode (LEDs rapidly flash for configuration

mode).

Reattach the note magazine.

Insert the completed configuration coupon and verify the settings were accepted by

counting the bezel flashes.

No. of Flashes

1 - 5

The coupon selection is stored in the unit until it is reprogrammed, even if the power is

off.

for instructions on how to download the configuration coupon referenced below. Follow the

Meaning

Configuration coupon was accepted, and the unit is successfully

programmed.

Coupon was rejected. The number of flashes corresponds to the

coupon section that was improperly filled out. Try again.

Coupon was not read. Confirm the coupon is correct and try again.

to press the

Published by CPI

Talos™ T6/T8 Note Validator

chapter 1.2

01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN