CPI TR30 Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Пульт дистанційного керування CPI TR30. CPI TR30 16 сторінок. Tone remotes
Друкувати сторінкуSPECIFICATIONS
Power Requirements
Dimensions
Weight
Audio Output to Speaker
Handset Earpiece Level
Frequency Response
Hum and Noise
Notch Filter
Compression
Line Impedance
Line Output Level
Control Tone Frequencies
Operating Modes
2
CONTENTS
Topic ..................................................... Page #
Specifications ..................................................... 2
General Description ............................................ 3
Installation ........................................................... 3
Jumper settings ................................................... 4
Dip switch settings ............................................... 4
Circuit Analysis ................................................... 5
Parts List ............................................................. 5, 6, 7
Control Panel PCB View ...................................... 8
Control Panel PCB Schematic ............................. 9
Main PCB View ................................................... 10
Main PCB Schematic .......................................... 11,12,13,14
External Adjustments ........................................... 15
Warranty ............................................................. 16
Subject to change without notice.
120 VAC, 60 Hz for wall pack (provided) operation
12 VDC to 16 VDC @ 600 mA maximum. Fused on circuit board.
9" x 4" x 7" inches
TR10 - 5 lbs, TR20 - 5 lbs, TR30 - 5 lbs, TR40 - 5 lbs.
2 Watts at 3% THD into 8 ohms, using supplied wall pack or 12 VDC.
Volume Control Adjustable.
+/- 3dB from 300 to 3000 Hz, except at notch freq. 1000 Hz reference.
50 dB below operating levels
2175 Hz down 50 dB from 1000 Hz reference level.
Less than 3 dB increase in output with 30 dB increase in input beyond
threshold. Threshold is adjustable from -20 dBm to +10 dBm.
600 ohms or 5000 ohms, dip switch selectable.
Factory set at 0 dBm. Adjustable to +10 dBm maximum.
Security Tone: 2175 Hz +/- 0.01% @ +10 dBm for 140 mS.
Function Tone: F1 1950 Hz +/- 0.01% @ 0 dBm for 40 mS.
Monitor Tone:
Hold Tone:
Standard: Two wire simplex
Optional: Two wire duplex, four wire simplex and four wire duplex.
F2 1850 Hz +/- 0.01% @ 0 dBm for 40 mS.
2050 Hz +/- 0.01% @ 0 dBm for 40 mS.
2175 Hz +/- 0.01% @ -20 dBm for duration of PTT.