Allied Telesis TurboStack AT-TSA5 Посібник користувача - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник користувача для Перемикач Allied Telesis TurboStack AT-TSA5. Allied Telesis TurboStack AT-TSA5 18 сторінок. At-tsax appliqués

Друкувати сторінку

3. Detach the AUI connector from the plate by removing the slide kit screws,

washers, and nuts.

4. Carefully pull the AUI connector from the hub faceplate to expose the ribbon

cable as shown in Figure 4.

5. Remove the plate from the ribbon cable by rotating the cable 90 and sliding it

through the slot in the plate.

To install a 10BASE2, 10BASE-T or fiber Optic (10BASE-FL)

appliqué

1. Plug the new appliqué into the AUI connector, after the connector has been

detached from the plate (Step 3 above).

2. Secure the new appliqué with the appliqué screws.

3. Slide the appliqué into the port cavity and screw it down. Do not overtighten.

4. Snap the plastic cover plate back in place on the hub faceplate.

To remove a 10BASE2, 10BASE-T or fiber Optic (10BASEFL)

appliqué

1. Snap off the plastic cover plate on the installed appliqué.

2. Remove the appliqué screws and pull out the appliqué.

3. Follow the steps for appliqué removal detailed above.

Figure 4: Appliqué Replacement

AT-TSAx Appliqués