DGA Mach 2 Технічна специфікація - Сторінка 2

Переглянути онлайн або завантажити pdf Технічна специфікація для Спорт & на свіжому повітрі DGA Mach 2. DGA Mach 2 2 сторінки. Permanent disc golf basket

Друкувати сторінку

DGA Mach 2™ Permanent Disc Golf Basket

Box includes: 1 base, 1 trapper basket, 1 chain holder, 1 long pole with cap, 1 swedged short pole,

3 long bolts (11mm), 3 locking nuts (11mm), 3 short bolts (10mm) and 1 focal point sticker.

You will need 10mm and 11mm wrenches or ratchets to tighten the bolts.

1) Remove all parts from inside the box. Place the base on level ground and insert the short pole into the base with the

swedged end facing up. Line up the poles three bottom bolt holes with the three bolt holes on the base. Push a long

bolt through both the base and pole bolt holes and tighten with a locking nut.

2) Place the longer pole with the cap side up onto the short pole' s swedged end and line up the three bolt holes on

both poles. Lift the trapper basket up onto the top of the pole. Slide the trapper basket down past the middle of the

pole and line up the three trapper basket bolt holes with the holes on the poles. Push a long bolt through the trapper

basket and the pole' s bolt holes. Tighten the long bolt with a locking nut.

3) Lift the chain holder up onto the top of the pole by ﬁrst feeding the two 4 inch rings that connect to the bottom of

the chain strands. Line up the three bolt holes on the chain holder and the poles top three bolt holes and push a long

bolt through the chain holder and pole bolt holes. Tighten the long bolt with a locking nut.

4) The base, trapper basket and chain holder each have one remaining hole for the 10mm short bolts. In each of the

remaining holes insert and tighten a short bolt to prevent the base, trapper basket and chain holder from wobbling on

the pole.

5) Attach the included focal point sticker so that the top of the sticker is about ﬁve inches from the top of the pole.

Start with lining up one end of the sticker so it is straight up and down in line with the pole and slowly wrap the focal

point sticker around the pole. The Mach Lite logo should be facing side ways on the pole.

Trapper Basket

Swedged

End

Short Pole

Locking

Long Bolt

Nut

Base

Step 1

Long Pole

Locking

with Cap

Nut

at Top

4 Inch

Rings

Locking

Long bolt

Nut

Step 2

Assembly Instructions

Chain Holder

Long Bolt

Step 3

DGA | The Founding Company of Disc Golf

DiscGolf.com 831-722-6037

Short Bolt

Focal Point

Sticker

Short Bolt

Step 4

Step 5