Avtech 702 Series Посібник з швидкого налаштування - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Камера спостереження Avtech 702 Series. Avtech 702 Series 7 сторінок.
Друкувати сторінку
PRODUCT OVERVIEW
I/O Terminal Block
This camera supports external I/O device connection, and a 4-pin I/O terminal block is supplied with this camera for easy
connection.
Below shows which input on the I/O terminal block you should use for wiring when you want to connect an external device to this
camera.
4-pin I/O Terminal block
d
Package Content
Before starting to set up your camera, please make sure
items below in your box:
Standard package:
Camera
Bracket
Selected models only:
RJ45 cable
CD Manual
DC 5V Relay
COM
NC
NO
GND
Alarm Out
GND
Alarm In
Magnetic Contact
Example of Alarm Out Connection
Insert Micro SD Card
Only selected models are equipped with a micro SD
card slot for local video recording.
The data originally saved in the micro SD card (if any) will
be removed after inserting it to the camera.
The camera doesn't support hot-swapping. Please insert or
remove the micro SD card with power disconnected.
I/O Terminal
Block
Adapter
Antenna
Assemble & Install
1. Fasten the base of the bracket (the round one) to where
The distance between your camera and the location you
want to monitor should be 3 ~ 4 meters.
2. Assemble the bracket and the camera, and adjust the
DC 12V
Power Supply
3. (For wireless models only)
Buzzer
4. Connect your camera to power, and check the LED status
Card slot on the left
Card slot on the right
the camera is installed.
viewing angle of the camera.
Fasten the antenna for wireless network connection.
indicators to make sure the camera is powered on.
701_702_702a_801_EZ_setup_V1.0
525Z