DGS Real Life Ninja Starter Pack 1 Інструкція з монтажу Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Аксесуари DGS Real Life Ninja Starter Pack 1. DGS Real Life Ninja Starter Pack 1 8 сторінок.

Друкувати сторінку
DGS - 17 Lucienne Ave. Danielson, CT 06239 - 800-932-3339 - [email protected]
1
Lay wall sections on side in appropriate order

View from above

2" Deck Screws
x 4
2" Deck Screws
Top
Turn wall 90 degrees onto back
2
View from Side
2" Deck Screws
Top
Middle
Tip wall into upright position
3
View from side
Remove previously installed screws
4
from one side only of bottom section
View from side
REMOVE
2" Deck Screws
ONE SIDE ONLY
Please visit gymsupply.com for product assembly videos.
x 6
Middle
Bottom
x 6
x 4
2" Deck Screws
Bottom
x 6
5
From inside the wall, secure the base section to
the middle section using 3" deck screws
through the abutting braces. Start at the side
which still has 2" deck screws installed, and
work your way across, making sure that the
front surface of the wall is ush.
Any overhang should be on the higher section,
so someone sliding down the face would not
catch on it.
Middle
Bottom
x 6
3" Deck Screws
Reinstall previously removed screws
6
from side of bottom section
View from side
REINSTALL
2" Deck Screws
ONE SIDE ONLY
7
Repeat steps 4 through 6 for
top/middle section. (12 and 14ft. walls only)
8
Move wall into nal position. Wall must be on
a rm level surface, such as concrete. Drill holes
through pre-installed brackets inside wall into
foor and install wedge bolts. (see next page)
Middle
Middle
Bottom
Bottom
x 6