CPT CPT Посібник з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Морське обладнання CPT CPT. CPT CPT 18 сторінок.
Друкувати сторінку© 2014 CPT Autopilot Inc.
Turn Power On with Rudder control. Wait at least 1 minute for pilot to warm up before using.
To Steer with pilot:
Hold boat on desired heading 30 seconds. Engage Clutch. Flip toggle switch to Hold Heading. Set Rudder and Deadband
To Hand steer: Flip toggle-switch to Standby & Disengage Clutch
* In an emergency, the wheel can be forced to overpower the clutch and shear the shear-pins
Rudder:
Determines proportionally how far to turn wheel (rudder) for corrections.
High settings turn boat's rudder more; Low settings turn boat's rudder less
Deadband: Determines "sensitivity" to boat heading changes. Use to adjust for sea conditions.
Low settings hold boat to a tighter heading
Lowest setting allows approximately ±1° heading range
High settings allow the boat to steer within a wider heading range
Setting of "5" allows approximately ±10° heading range
1°and 10° buttons: Push and release buttons to adjust heading; changes target heading
Check boat headway and rudder/deadband if boat is not responding (1° button will not be immediate)
Tacking: Hold down 1° & 10° buttons for the direction you wish to tack. Hold both buttons down for 5 seconds. Release
buttons to begin tack. Set deadband low for more accuracy.
* Flip to Standby and disengage clutch if stuck in irons or no wind to prevent wheel hitting rudder-stops
Change Tack Angle: hold both 10° Port and 10° Starboard buttons down at the same time. Turn deadband dial to new tack
angle and release buttons to set. Remember to return deadband dial to desired deadband setting afterwards.
* Tack angles are approximate and will vary from boat to boat based on the magnetic environment. You will have to see
which angle works best for your boat.
For autopilot steering, first engage
clutch, then flip up to Hold Heading
Hold both for 5 seconds,
then release to initiate tack
Higher Rudder setting
makes larger wheel
corrections
Turn to power on and allow
one minute to warmup
www.cptautopilot.com
CPT Operation
For hand steering, first flip down to
Standby then disengage clutch
HOLD
1°
HEADING
PORT
10°
STANDBY
5
4
6
4
80°
3
7
3
2
8
2
1
9
1
60°
off
10
min
RUDDER
DEADBAND
Press and release to
adjust heading
+1°
STARBOARD
+10°
Wait for boat to reach new
heading before pressing
more than three times, 30°
100° t ack angle
5
6
120°
7
Turn Deadband dial
(dead range) to minimum
8
for highest sensitivit y
9
10
Page 2 of 17