Avtech DGC1304XFT Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Камера спостереження Avtech DGC1304XFT. Avtech DGC1304XFT 7 сторінок. Ir dome camera
Друкувати сторінку
MENU
IMAGE
MOTION
LSC
MIRROR
BPC
PICT ADJ
SYSTEM
CAM TITLE
LANGUAGE
FORMAT
EXIT
SAVE&END
NOT SAVE
RESET
ON (SOLID)
AREA SEL
POSITION
SENSITIVITY
COLOR
TRANS
ON / OFF
OFF / ON
DYNAMIC
STATIC W
STATIC B
SHARPNESS
0 ~ 15
CB GAIN
0 ~ 255
CR GAIN
0 ~ 255
BLACK LEVEL
-128 ~ 127
GAMMA
0.4 / 0.45 / 0.5
OFF / ON
ENG / CHI S
NTSC / PAL
DESCRIPTION
Click
to set the area you want to detect. Up to four
areas could be configured.
The area will be masked and flashed when a motion
event occurs.
Choose ON to show where the area selected in AREA
SEL is and set the size of the area:
1. Click
and change the
size by clicking
,
,
and
.
3. Click
again to finish and exit.
Set the sensitivity for motion detection from 1 to 24.
The larger the value, the more sensitive the detection.
Choose the color for the selected area to show when a
motion event occurs: RED / GREEN / BLUE / WHITE.
Choose the transparent level for the selected area from 1
~ 8 when a motion event occurs.
The larger the value, the more transparent the area.
Enable (ON) or disable (OFF) Lens Shading Correction
to correct the phenomenon of vignetting when the focal
length is short.
Enable (ON) to turn the images horizontally based on
your installation situation when necessary.
BPC (bad point compensation) is used to compensate
dead pixels in the image.
to further configure DYNAMIC /
Click
STATIC W (white) / STATIC B (black).
Set the level of sharpness to enhance the clarity of image
detail by adjusting the aperture and sharpening the
edges.
The more the value, the sharper the image will be.
Adjust the blue value.
Adjust the red value.
Adjust the level of black.
Choose for gamma correction.
Set the camera ID.
Select the language of the menu: English / Simplified
Chinese.
Choose to change the video system format if needed.
Save all the changes made and exit.
Quit without saving.
Reset to factory default values.
2. Click
again and
change the size by clicking
,
,
and
.