Dell 5530 Mono Laser Посібник з експлуатації - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Ноутбук Dell 5530 Mono Laser. Dell 5530 Mono Laser 46 сторінок. Loading paper and specialty media
Також для Dell 5530 Mono Laser: Короткий довідник (2 сторінок), Посібник з налаштування та специфікацій (29 сторінок), Налаштування та технічні характеристики (29 сторінок)

Installing the Base Cover

Place the base cover on the computer and snap it in place.

Tighten the M2x3 T5 (10), M2x8 (2) screws to secure the base cover to the computer.

NOTE:

Ensure you use a Torx #5 screwdriver for the base screws and a Philips screwdriver for the two M2x8 system badge

screws.

Turn the system badge flap over and snap it in place.

Follow the procedures in

Battery

NOTE:

Discharge the battery as much as possible before removing from the system. This can be done by disconnecting the A/C

adapter from the system (while the system is turned on) to allow the system to drain the battery.

NOTE:

System shipped with 3-Cell battery has 4 screws, the hard drive will be part of the configuration (Optional).

Follow the procedures in

Remove the

base cover

Perform the following steps to remove the battery:

Disconnect the battery cable from the system board [1].

b Remove the M2x4 (7) screws that secure the battery to the computer [2].

Lift the battery off the computer [3].

•

Do not apply pressure to the surface of the battery

•

Do not bend

•

Do not use tools of any kind to pry on or against the battery

•

If a battery cannot be removed within the constraints above, please contact Dell technical support

After Working Inside Your

Computer.

Before Working Inside Your

Computer.

Disassembly and reassembly