DGSHAPE LC-3DPrint Box Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для 3D-принтери DGSHAPE LC-3DPrint Box. DGSHAPE LC-3DPrint Box 12 сторінок.
Друкувати сторінку2.0 Installation
2.1 Check the package contents
-
DGSHAPE LC-3DPrint Box
-
AC Power cable
-
6pcs of UV-18W lamps-71color
-
6pcs of UV-18W lamps-78 color
-
Inside metal grid
-
Users Instruction Manual (This
document)
-
Declaration of conformity
2.2 Transportation and preparing
the area where the NextDent LC-
3DPrint Box will stand
-
For units weighing more than 22 kg. At
least two persons are needed for
transportation and installation.
-
The surface should be flat and dust
free.
-
Make sure there is enough space on
all sides.
-
Make sure that there is enough space
between fan and wall.
-
This unit is for indoor use only.
2.3 Environmental conditions
-
Power on
o
Temperature：20°C-30°C(68°F-
86°F),Humidity：35%-
80%（non-condensing）
-
Power off
o
Temperature：5°C-40°C(41°F-
104°F),Humidity：20%-
80%（non-condensing）
-
Indoor use only
2.4 Steps for installation
-
Please read all operation instructions.
-
Specially read general caution
including safety information.
-
Connect all the lamps (12pcs) to all
the lamp sockets which are placed in
the cover and the chamber.
page 4 / 12
The recommended position of the
-
supplied lamps( 6pcs of 18W lamps-
71color and 6pcs of 18W lamps-
78color) is as shown in picture.
Cover Inside
Chamber Inside
FPL 18W 71 color x 6pcs
FPL 18W 78 color x 6pcs
-
Please make sure of rated voltage and
power supply. Only the supplied
power cable can be used.
-
Connect the power cable with EU
connector plug to the power socket.
When
replacing
always disconnect the power
cable, or turn off the machine.
Make sure you change the correct
color lamp 71/78!
the
lamps,