Dell i1470-2932CRD - Inspiron 1470 Cherry Посібник з експлуатації - Сторінка 24

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Ноутбук Dell i1470-2932CRD - Inspiron 1470 Cherry. Dell i1470-2932CRD - Inspiron 1470 Cherry 46 сторінок. Service manual

Back to Contents Page
  Keyboard
Dell™ Inspiron™ 1470/1570 Service Manual 
  Removing the Keyboard
  Replacing the Keyboard
 
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
 
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
 Removing the Keyboard
 
1. Follow the procedures in
Before You
 
2. Remove the battery (see
Removing the
 
3. Remove the power button cover (see
 
4. Remove the two screws that secure the keyboard to the palm rest.
 
5. Use the metal tabs along the top edge of the keyboard to lift it up at an angle, then ease the keyboard tabs along the bottom of the keyboard out of
the palm rest.
 
CAUTION:
The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
keyboard.
 
CAUTION:
Be extremely careful when removing and handling the keyboard. Failure to do so could result in scratching the display panel.
 
6. Lift the connector latch on the keyboard cable to disconnect it from the connector on the system board.
 
7. Lift the keyboard off the palm rest.
1
screws (2)
3
keyboard
5
latch on connector
 Replacing the Keyboard
Begin.
Battery).
Removing the Power Button
Cover).
2
metal tabs (2)
4
keyboard tabs (5)
6
keyboard cable
Removing the
Battery) before working inside the