Avtech AVD715ZD Посібник із швидкого старту - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для ВІДЕОРЕЄСТРАТОР Avtech AVD715ZD. Avtech AVD715ZD 16 сторінок. High-end series

3.2 Camera Connection

The cameras must be connected and power-supplied before the DVR is turned on. For detailed DVR video input /

output ports, please refer to section "2. REAR PANELS" at page 1. For detailed external I/O port description, please refer

to the section "5. PIN CONFIGURATION" at page 13. For detailed camera setup, please refer to its own manual.

3.2.1 Normal Camera Connection

1) Connect the camera with indicated power supply.

2) Connect the camera video output signal to DVR video input port with coaxial cables or RCA line with BNC connector.

For detailed camera title, ID, protocol and baud rate setup, please refer to section "6.4.5 Remote" at page 32 of the

manual.

1) Connect the PTZ camera with indicated power supply.

2) Connect the PTZ camera video output to the DVR video input port with a coaxial cable or RCA line with BNC

connector.

3) Connect "RS485-A" line (brown color) to RS485-A port on the rear panel of the DVR. Connect "RS485-B" line (orange

color) to RS485-B port on the rear panel of the DVR.

NOTE: For detailed camera ID, protocol and baud rate setup at DVR side, please refer to section "6.4.5 Remote" at page 32

of the manual.

For detailed camera ID, protocol and baud rate setup at remote AP software side, please refer to section "(1)

Device" at page 55 of the manual (AP software system configuration). For detailed PTZ setup and control instructions,

please refer to section "6.6.5 PTZ Camera Setup and Control" at page 42 of the manual.

Page 3

QUICK INSTALLATION