Dell Precision 3930 Rack Налаштування та технічні характеристики - Сторінка 27
Переглянути онлайн або завантажити pdf Налаштування та технічні характеристики для Ноутбук Dell Precision 3930 Rack. Dell Precision 3930 Rack 37 сторінок.
Також для Dell Precision 3930 Rack: Посібник з монтажу (13 сторінок)
Друкувати сторінку
Power management
Table 25. Power Management
Option
AC Recovery
Enable Intel Speed Shift
Technology
Auto On Time
Wake on LAN
Block Sleep
Thermal configuration
Table 26. Thermal configuration
Option
Thermal Mode
CPU Zone
PSU Zone
Description
Determines how the system responds when AC power is re-applied after a power loss. You can set
the AC Recovery to:
•
Power Off—Default
•
Power On
•
Last Power State
This option is Power Off by default.
Allows you to enable or disable Intel Speed Shift Technology support. The option Enable Intel Speed
Shift Technology is set by default.
Sets time to automatically turn on the computer. Time is kept in standard 12-hour format
(hour:minutes:seconds). Change the startup time by typing the values in the time and AM/PM fields.
NOTE:
This feature does not work if you turn off your computer using the switch on a
power strip or surge protector or if Auto Power is set to disabled.
This option allows the computer to power up from the off state when triggered by a special LAN
signal. This feature only works when the computer is connected to AC power supply.
•
Disabled - Does not allows the system to power on by special LAN signals when it receives a
wake-up signal from the LAN.
•
LAN - Allows the system to be powered on by special LAN.
•
LAN Only - Allows the system to be powered on by special LAN signals.
•
LAN with PXE Boot - A wakeup packet sent to the system in either the S4 or S5 state, that will
cause the system to wake-up and immediately boot to PXE.
This option is Disabled by default.
Allows you to block entering to sleep in OS environment. This option is disabled by default.
Description
Allows you to determine the speed of the system fans. This option is enabled by default.
•
Low
•
Auto (Default)
This option is set to Auto by default.
NOTE:
This setting applies to all the Zone
Allows you to control the minimum and maximum fan speed in the CPU Zone. The range of
characters is between 0 and 100.
NOTE:
When Thermal Mode is set in auto, Zero is the optimal speed level.
Allows you to control the minimum and maximum fan speed in the PSU Zone. The range of
characters is between 0 and 100.
NOTE:
When Thermal Mode is set in auto, Zero is the optimal speed level.
System setup
27