Dell Dimension 2400 Series Посібник - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник для Робочий стіл Dell Dimension 2400 Series. Dell Dimension 2400 Series 43 сторінки. Vga card installation instructions
Також для Dell Dimension 2400 Series: Посібник з швидкого налаштування (2 сторінок), Посібник з швидкого налаштування (2 сторінок), Посібник з монтажу (20 сторінок), Посібник з інсталяції (8 сторінок), Інструкція з монтажу стійки (32 сторінок), Інструкція з монтажу (1 сторінок)

Dell Dimension 2400 Series Посібник
 
 
NOTICE:
Lay the heat sink down with the thermal grease facing upward.
 
NOTICE:
If you are installing a microprocessor upgrade kit from Dell, discard the original heat sink. If you are not installing a microprocessor upgrade kit
from Dell, reuse the original heat sink when you install your new microprocessor.
 
NOTICE:
Be careful not to bend any of the pins when you remove the microprocessor from the socket. Bending the pins can permanently damage the
microprocessor.
10.  Remove the microprocessor from the socket.
 
Leave the release lever extended in the release position so that the socket is ready for the new microprocessor.
 
 

Installing the Microprocessor

 
NOTICE:
Ground yourself by touching an unpainted metal surface on the back of the computer.
 
NOTICE:
Be careful not to bend any of the pins when you unpack the microprocessor. Bending the pins can permanently damage the microprocessor. If
any of the pins on the microprocessor appears to be bent, see "Contacting Dell" in the Owner's Manual for instructions on obtaining technical assistance.
1.  Unpack the new microprocessor.
 
NOTICE:
You must position the microprocessor correctly in the socket to avoid permanent damage to the microprocessor and the computer when you
turn on the computer.
2.  If the release lever on the socket is not fully extended, move it to that position.
3.  Align the pin-1 corners of the microprocessor and socket.