ensto eFiller Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Зарядний пристрій ensto eFiller. ensto eFiller 12 сторінок.

3.2 Installation to Wall

When selecting the installation location, make sure that the wall material is suitable and ro-

bust. The mounting surface should be flat and vertical (± 10°).

•

Remove the stainless steel top cover by removing the four torx screws.

•

Take the cable routing into consideration when planning the installation. The supply cable

can be routed into the enclosure from the rear or bottom. Install the lead through plate

depending on the cable entry direction.

•

Prepare the wall for installation and select the screw type depending on the wall type.

Recommended screw diameter is 6mm - 8mm. The mounting screw spacing is 120mm x

185mm. Exercise extreme caution when drilling holes in the wall. Make sure there are no

electrical cables inside the wall.

•

Select the drill size to match the screw size.

•

Drill open the mounting hole points in the back of the aluminum enclosure.

•

Install the aluminum enclosure to the wall.

•

Place rubber washers between the wall and the enclosure.

Figure 1

Cable lead through

plate orientation, if

cable entry is from

rear

Rubber washer

Possible supply cable

entry directions

Cable lead through

plate orientation, if

cable entry is from

bottom