Allied Telesis AT-8600 Series Примітка до випуску - Сторінка 2
Переглянути онлайн або завантажити pdf Примітка до випуску для Програмне забезпечення Allied Telesis AT-8600 Series. Allied Telesis AT-8600 Series 6 сторінок. Virtual chassis stacking
Також для Allied Telesis AT-8600 Series: Усунення несправностей (5 сторінок), Брошура (12 сторінок), Як налаштувати (9 сторінок), Брошура (8 сторінок)
Друкувати сторінку
2
Some of the issues addressed in this Release Note include a level number. This
number reflects the importance of the issue that has been resolved. The levels
are:
This issue will cause significant interruption to network services, and
Level 1
there is no work-around.
Level 2
This issue will cause interruption to network service, however there
is a work-around.
Level 3
This issue will seldom appear, and will cause minor inconvenience.
This issue represents a cosmetic change and does not affect network
Level 4
operation.
Features in sr264-03
Patch sr264-03 includes all issues resolved and enhancements released in
previous patches for Software Release 2.6.4, and the following enhancements:
PCR: 31225
Module: IPG
While the switch was set with a CIDR interface address, when it received an
ECHO request with a network broadcast destination address for a class C
network, the switch sent the ECHO reply packet. Also, the switch
forwarded the ECHO request packet using a broadcast MAC address. These
issues have been resolved.
PCR: 40355
Module: VRRP
When an IP interface is in a down state and VRRP is configured on the
interface, VRRP should be disabled. If it was enabled, VRRP could
transition to "INITIAL" state. This issue has been resolved.
PCR: 40357
Module: SW56
The L3 filter nomatchaction parameter was not applied for some IP traffic
on the switch. This issue has been resolved.
PCR: 40405
Module: ENCO
If the ENCO process used to encrypt an ISAKMP packet failed, a switch
reboot could occur. This issue has been resolved.
PCR: 40415
Module: VRRP
When a master VRRP router was configured from a boot script, the
transition to the MASTER state occurred before the Layer 2 interface had
been initialised, preventing the gratuitous ARP from being sent. This issue
has been resolved.
Patch Release Note
Level: 3
Level: 2
Level: 2
Level: 2
Level: 2
Patch sr264-03 for Software Release 2.6.4
C613-10407-00 REV C