Dell 6100 Посібник з експлуатації обладнання - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник з експлуатації обладнання для Сервер Dell 6100. Dell 6100 15 сторінок. Dell poweredge 4200 servers: installation guide
Також для Dell 6100: Встановлення в стійку (37 сторінок), Додатковий посібник (4 сторінок), Встановлення в стійку (34 сторінок)

Dell PowerEdge 6100/200 System Microprocessor Replacement

release lever

Figure 8. Removing a Microprocessor

6. Lift the microprocessor out of its socket.

To install the replacement microprocessor/heat sink assembly, ensure that the

microprocessor release lever is in its fully vertical position to allow the micro-

processor pins to easily slip into the socket. When the microprocessor/heat sink

assembly is in place, rotate the microprocessor release lever to its horizontal

position. Hook the microprocessor securing clip over the socket tab nearest the

front of the system board, and then snap it over the tab on the back of the socket.

Pin 1 on the microprocessor is located on the corner with the largest bevel and

the top of the chip also may have a dot (see Figure 9). The pin-1 hole in the

microprocessor socket is located on the corner where the holes are in a diagonal

pattern.

Figure 9. Pin-1 Identification

Correct any necessary jumper settings on the microprocessor module (see Fig-

ure 5 and Table 1) if you add or remove a microprocessor. Verify that the system

setup program and the system configuration utility settings are correct after the

system is reassembled and turned on. See your system User's Guide for more

information about these settings.

microprocessor chip

pin-1 corner of

chip and socket

aligned

pin-1 corner

(dot and/or

notched corner)