Dell Dimension 2200 Посібник - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник для Сервер Dell Dimension 2200. Dell Dimension 2200 50 сторінок. Vga card installation instructions
Також для Dell Dimension 2200: Посібник із заміни (9 сторінок), Інструкція з монтажу (1 сторінок)
Друкувати сторінку
An error is occurring on the timer on the system
CH-2 Timer Error
board.
The system configuration information in the system
CMOS Battery State
setup program is incorrect, or the battery charge
Low
may be low.
CMOS Checksum Failure
CMOS System Options
Not Set
CMOS Display Type
Mismatch
CMOS Memory Size
Mismatch
CMOS Time and Date
Not Set
Drive A or B is present but has failed the BIOS POST. Ensure that the drive is installed correctly in the computer and defined
Diskette Boot Failure
Error in the DMA controller on the system board.
DMA Error
DMA 1 Error
DMA 2 Error
BIOS cannot communicate with the floppy drive or
FDD Controller
hard drive controller.
Failure
HDD Controller
Failure
Interrupt channel on the system board failed to
INTR1 Error
POST.
INTR2 Error
The operating system cannot be located on drive A
Invalid Boot Diskette
or drive C.
The BIOS has detected a stuck key.
Keyboard Error
An error occurred with the keyboard connector.
KB/Interface Error
The operating system cannot be located on drive A
No ROM Basic
or drive C.
Back to Contents Page
See "Contacting Dell" in the Owner's Manual for instructions on obtaining
technical assistance.
Enter the
system setup program
and verify the system configuration; then
restart the computer.
correctly in the
system setup
program. Check the interface cable at both
ends.
The keyboard or
system board
may need to be replaced.
Ensure that the
floppy drive
or the
computer and defined correctly in the
interface cable at both ends.
The keyboard or
system board
may need to be replaced.
Enter the
system setup program
and confirm that drive A or drive C is
properly identified.
Make sure that nothing is resting on the keyboard; if a key appears to be
stuck, carefully pry it up. If the problem persists, you may need to replace
the keyboard.
Make sure that nothing is resting on the keyboard; if a key appears to be
stuck, carefully pry it up. If the problem persists, you may need to replace
the keyboard.
Enter the
system setup program
and confirm that drive A or drive C is
properly identified.
hard drive
is installed correctly in the
system setup
program. Check the