Dell DX Object Storage Довідковий посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Довідковий посібник для Сервер Dell DX Object Storage. Dell DX Object Storage 12 сторінок. Dell dx object storage architectural reference guide

Dell DX Object Storage – File Gateway Architectural Reference

Network

For a failover CFS configuration, the iSCSI storage can be on its own switch isolated from the DX
Storage Cluster or it can be attached to the DX Cluster network. In cases where iSCSI storage is
attached to the DX Cluster network, then ports 2 thru 5 can be shared between the iSCSI storage and
DX Storage Cluster. In this configuration, it is recommended to configure network ports for adaptive
load balancing. Sites that have suitable competence may prefer configuration and management of link
aggregation control protocol in place of adaptive load balancing.
The preferred failover network configuration is identical to that shown for a single-server CFS
configuration (above), except that iSCSI traffic will share the four NIC ports that go to the private DX
Storage network. If a site wishes to use pre-existing iSCSI storage that is available on its own VLAN,
then the recommended network port allocation is:
Connect NIC ports 0 and 1 to the CIFS/NFS network.
Connect NIC ports 2 and 3 to the DX Storage Cluster network.
Connect NIC ports 4 and 5 to the iSCSI Storage network.

Gateway Protocols

The CFS can be configured for NFS or SMB/CIFS gateways. For SMB/CIFS, users and groups can access
the system through standalone authentication, or if Active Directory Services exists, users and groups
can be authenticated through the existing ADS structure. For NFS, Dell supports version 3 only; it does
not support version 4.
Page 6