Dell Force10 S2410 Посібник із швидкого старту - Сторінка 23

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Сервер Dell Force10 S2410. Dell Force10 S2410 31 сторінка. Installing the s2410 system
Також для Dell Force10 S2410: Посібник (42 сторінок)

Друкувати сторінку

Enabling Ports

When the S2410 is first installed, all ports are disabled by default. You can use

the no shutdown command for a specific interface (Interface Config mode). To

enable all ports, enter no shutdown all in Global Config mode.

Setting the IP Address for the Service Port

The S2410 supports the Ethernet Management port (labeled 10/100 Ethernet and

commonly called the service port). It is a dedicated management port (in

addition to the console port and the virtual management port). You can use the

service port to access the switch through Telnet, SSH, TFTP, or the SFTOS Web

UI.

Step Task

Specify the network

configuration protocol to be

used (Bootp or DHCP) for

configuring access to the

Ethernet Management port.

Alternatively, leave the default

at none to require the Ethernet

Management port to be

manually configured with IP

information.

If you left the default at none,

manually configure the IP

address, IP subnet mask, and

default IP gateway of the

Ethernet Management port.

Verify the service port

configuration.

Command Syntax

serviceport protocol {none

| bootp | dhcp}

serviceport ip ipaddr

netmask [gateway]

show serviceport

Installing the Software

Command Mode

Global Config

Privileged Exec