Dell Force10 S2410-01-10GE-24P Посібник - Сторінка 28
Переглянути онлайн або завантажити pdf Посібник для Сервер Dell Force10 S2410-01-10GE-24P. Dell Force10 S2410-01-10GE-24P 42 сторінки. Installing the s2410 system
Також для Dell Force10 S2410-01-10GE-24P: Примітка до заявки (6 сторінок), Посібник із швидкого старту (31 сторінок)
Друкувати сторінку
Power Supply
Parameter
Nominal Input Voltage
Maximum Current Draw
Maximum Power Consumption
Load balancing and redundant AC power
NOTE: S2410 switches contain a lithium clock battery that is not user-serviceable. The switch contains no
user-serviceable parts. For details on recycling the switch or any of its components, see
Disposal on page
Agency Compliance
The S2410 is designed to comply with the following safety and agency requirements.
USA Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These
limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the
instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell Force10 is not responsible for
any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications
in the equipment. Unauthorized changes or modification could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Canadian Department of Communication Statement
European Union EMC Directive Conformance Statement
This product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on the approximation of the laws of the
Member States relating to electromagnetic compatibility. Force 10 Networks can not accept responsibility for any failure to satisfy the protection
requirements resulting from a non-recommended modification of this product, including the fitting of non-Dell Force10 option cards.
This product has been tested and found to comply with the limits for Class A Information Technology Equipment according to CISPR 22/
European Standard EN 55022. The limits for Class A equipment were derived for commercial and industrial environments to provide reasonable
protection against interference with licensed communication equipment.
WARNING: This is a Class A product. In a domestic environment, this device may cause radio interference, in
which case, the user may be required to take adequate measures.
28
|
S2410 Specifications
Specifications
100 - 240 VAC, 50/60 Hz, auto-sensing
S2410CP: 1.5 A @ 100/120 VAC,.575 A @ 200/240 VAC
S2410P: 2.05 A @ 100/120 VAC, 1.025 A @ 200/240 VAC
S2410CP: 125W
S2410P: 225W (3.5W per XFP)
Both the S2410CP model and the S2410P have two AC inputs that connect
to separate sets of power modules for 1+1 redundancy.
30.
Product Recycling and