Avtron Sigma Control Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Шлюз Avtron Sigma Control. Avtron Sigma Control 2 сторінки. Wireless gateway

Друкувати сторінку

User Configured Access Point

If you wish to connect your SIGMA Wireless Gateway to your own wireless access

point(s) please follow the instructions below.

1. Connect and power up the access

point/s or ensure existing wireless

network is available.

5. Add .conf file to the root of a

USB flash drive and insert into each

Gateway. The red LED will illuminate

when the update has completed.

9. Use SIGMA Network Pro or

Modbus based software to discover

and connect to the Gateway(s).

Avtron Power Solutions

NJ Froment & Co Ltd, Cliffe Road, Easton-on-the-Hill

Stamford, PE9 3NP, UK

2. Connect the DB9 cable into the

Gateway and connect to the load

bank.

6. Remove the USB drive. If the net-

work is available the green LED will

blink every second, otherwise it will

blink every 200ms.

The SIGMA Wireless Gateway can

also be configured as an Access

Point (AP). Please contact our

support team for more information:

[email protected]

3. Power up load bank.

7. For SIGMA LT load banks press

and hold mode for 3 seconds to

display IP address of the wireless

Gateway.

Please update your load bank to the latest firmware. Download from

website SIGMA Wireless Gateway Technical Documents.

# wpa_supplicant.conf

# Wi-Fi AP configuration file

ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev

update_config=1

country=GB

network={

ssid="LOADBANK_AP1"

psk="loadbank12"

}

# dhcpcd.conf

# customer network config

# comment out all config lines to get IP address from DHCP

# wired interface static IP address

interface eth0

static ip_address=172.29.0.10/19

static routers=172.29.0.1

static domain_name_servers=8.8.8.8

#wireless interface static IP address

interface wlan0

static ip_address=172.29.0.10/19

static routers=172.29.0.1

static domain_name_servers=8.8.8.8

[email protected] • +44 (0) 1780 480033

4. Download wpa_supplicant.

conf from website SIGMA

Wireless Gateway Technical

Documents. The file allows

the user to edit the Wi-Fi AP

configuration. Open the file

in a text editor and for each

additional gateway repeat the

network code snippet.

8. If you wish to create static IP

addresses for each Gateway, please

download dhcpcd.conf from website

SIGMA Wireless Gateway Technical

Documents. Open the file in a text

editor and enter required static IP

address for the Gateway. Add the

updated dhcpcd.conf file to the

route of a USB drive. Plug the USB

drive into the Gateway. The red LED

will illuminate when the update has

completed. Please contact us for

scripts that update multiple gateway

IP addresses.