Dell PowerApp 220 Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з монтажу для Сервер Dell PowerApp 220. Dell PowerApp 220 8 сторінок. Rack installation guide
Також для Dell PowerApp 220: Посібник з монтажу стійки (40 сторінок)
Друкувати сторінкуCAUTION: Positioning the microprocessor incorrectly can permanently damage
the microprocessor and the system when you turn on the system.
Install the microprocessor in the socket.
10
a
NOTICE: When placing the microprocessor in the ZIF socket, be sure that all of the pins on the
microprocessor go into the corresponding holes. Be careful not to bend the pins.
b
c
Install the heat sink.
11
•
•
•
Refer to your system information label on the system cover for the correct heat sink
orientation.
NOTICE: To avoid possible damage to the microprocessor, you must align the heat sink so that
the triangular mark on the heat sink points toward the triangular mark on the system board.
To replace the retention clip, orient the clip as shown on the system information label.
12
Hook the end of the clip without the release tab over the tab on the edge of the socket.
13
Press down on the release tab until the hole on the clip latches onto the ZIF socket
14
tab.
If you are adding a secondary microprocessor, examine the VRM to ensure that it is the
15
correct VRM for your system.
Insert the VRM in the appropriate secondary VRM socket, making sure that the
16
latches at each end of the socket engage (see Figure 1-4).
1-4
M i c r op r o c es s o r Up g r a d e Ins ta l l a ti o n Gui de
If the release lever on the ZIF socket is not in the upright position, move it to that
position now.
With the pin-1 corners of the microprocessor and socket aligned, set the
microprocessor lightly in the socket and make sure that all pins are matched with
the correct holes in the socket.
Because the system uses a ZIF microprocessor socket, there is no need to use force
(which could bend the pins if the chip is misaligned). When the microprocessor is
positioned correctly, it should drop down into the socket with minimal pressure.
When the microprocessor is fully seated in the socket, rotate the socket release
lever back down until it snaps into place, locking the microprocessor in the socket.
If the heat sink provided has a foil thermal interface material strip on the bottom
of the heat sink, place the heat sink on the microprocessor.
If the heat sink provided has a thermal grease tab, remove the tab and place the
heat sink on the microprocessor.
If heat sink thermal grease is provided, clean the heat sink and apply the thermal
grease before placing the heat sink on the microprocessor.