Dell PowerEdge 1955 Посібник із швидкого старту - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Сервер Dell PowerEdge 1955. Dell PowerEdge 1955 12 сторінок. Using dell blade servers in a dell poweredge high availability cluster
Також для Dell PowerEdge 1955: Посібник з використання (44 сторінок)
Друкувати сторінку
Before You Begin
This document describes how to insert the Brocade SilkWorm 4016 switch into a Dell PowerEdge 1855 chassis and
perform basic initial configuration. It provides the following information:
•
"SilkWorm 4016 Features,"
•
"Port Side" on page 4
•
"Unpacking the SilkWorm 4016" on page 5
•
•
"Configuring the Brocade SilkWorm 4016" on page 8
•
"Backing Up the Configuration" on page 11
•
"Configuring the Fibre Channel Ports" on page 11
•
"Optional Software Features" on page 12
•
"Where to Go Next" on page 12
To ensure proper installation of the SilkWorm 4016, read this entire document before beginning.
SilkWorm 4016 Features
The SilkWorm 4016 provides the following features:
•
Up to six external autosensing (1, 2, and 4 Gbit/sec) Fibre Channel ports:
-
Universal and self-configuring: capable of becoming an F_Port (fabric enabled), FL_Port (fabric loop enabled),
or E_Port (expansion port)
-
Brocade ISL Trunking of external ports with trunking license
•
Up to ten copper backplane F_ports with automatic negotiation to the highest common speed of all devices connected
to port, up to 2 Gbit/sec
•
Frame filtering that augments the hardware zoning capabilities of the Brocade ASIC, which implements hardware
zoning at the port level of the switch
•
Brocade ASIC expanded capabilities, including World Wide Name (WWN) and device-level zoning
•
Hardware zoning, implemented by means of a firmware-accessible table per output port
•
Extensive diagnostics and monitoring capabilities
•
Unicast and broadcast data traffic support
•
Four SWL small form-factor pluggable (SFP) optical transceivers
•
One console port through the backplane connectors to the DRAC/MC; refer to the PowerEdge 1855 documentation
for details about the connection
•
One 10/100 Mbit/sec autosensing Ethernet port with an RJ-45 connector with manual override for speed, and full/half
duplex operation
•
Light-emitting diodes (LEDs) for each external port:
-
One green/amber LED to indicate status for each port
-
One green/amber LED to indicate link speed for each port
SilkWorm 4016 Quickstart Guide
Publication Number: Publication Number: 53-100051-01
next
3 of 12