Dell PowerEdge 2550 Посібник з монтажу - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з монтажу для Сервер Dell PowerEdge 2550. Dell PowerEdge 2550 26 сторінок. Wake-on-lan (wol) support on dell servers
Також для Dell PowerEdge 2550: Посібник з інсталяції (32 сторінок), Посібник з конфігурації (10 сторінок), Інструкція з монтажу стійки (40 сторінок), Інструкція з активації (32 сторінок), Посібник з монтажу (32 сторінок), Посібник (28 сторінок), Посібник (15 сторінок)

support.dell.com

Installing the Rack Kit

NOTE: For instructions on installing the system itself, see "Installing the System in

the Rack" found later in this guide.

To install the rack kit in the rack, perform the following steps:

Remove the rack's front and back doors.

Install the slide assemblies in the rack.

The subsections that follow include instructions for performing these tasks.

You must remove the doors from the rack to provide access to the interior of the rack

and to prevent damage to the doors while installing the system.

This procedure provides instructions for removing doors from Dell 24-U and 42-U

racks. If you have a Dell PowerEdge 4210 rack, see the procedures contained in the

Dell PowerEdge 4210 Rack Installation Guide.

To remove the doors, perform the following steps.

CAUTION: To prevent personal injury due to the size and weight of the

doors, never attempt to remove the doors by yourself.

Open the latch on the front door.

If you have a 24-U (1 U=1.75 inches) rack cabinet, unlock and twist the handle

clockwise and open the door (see Figure 1-2).

Rack Installation Guide

1-3