Dell PowerEdge 4210 Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Сервер Dell PowerEdge 4210. Dell PowerEdge 4210 10 сторінок. Cabling poweredge t610
Також для Dell PowerEdge 4210: Посібник (20 сторінок), Посібник (20 сторінок), Посібник (17 сторінок), Посібник (12 сторінок), Посібник (10 сторінок), Посібник (9 сторінок), Посібник (9 сторінок), Посібник (10 сторінок), Посібник з монтажу (24 сторінок), Посібник (12 сторінок), Посібник (11 сторінок), Посібник (8 сторінок)

Cabling the Dell™ PowerEdge™ R610

Cabling a PowerEdge R610 without a CMA

NOTE: The CMA on the Dell PowerEdge R610 is optional. Without the CMA installed, the system must be powered

down and all cables disconnected before it can be removed from the rack.

3.1 Routing the Cables

1. Plug in all applicable cables to the rear of the system, verifying that all connections are secure.

2. Using the hook and loop straps supplied with the rail kit, bundle the cables and secure them to either the left

rail or right rail CMA attachment brackets as described in the Rack Installation Guide. See Figure 7 for an

example of power cables secured to the left CMA bracket and data cables secured to the right CMA bracket.

3. It is recommended that the cables be secured to the outer brackets, but cables may be secured to the inner

brackets if desired.

Figure 7: Cable Routing Without a CMA

3.1 Removing the CMA Brackets for Shallow Racks

If you are installing the system into a shallow rack (less than 1m deep) and you will not be installing a CMA, the

outer CMA brackets may be removed, enabling the rails to fit into the rack. Remove the outer CMA brackets by

removing both screws with a #2 Philips screwdriver as shown in Figure 8.

Figure 8: Removing the CMA Brackets for Shallow Racks

Page 6