Dell PowerEdge 4210 Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Сервер Dell PowerEdge 4210. Dell PowerEdge 4210 11 сторінок. Cabling poweredge t610
Також для Dell PowerEdge 4210: Посібник (20 сторінок), Посібник (20 сторінок), Посібник (17 сторінок), Посібник (12 сторінок), Посібник (10 сторінок), Посібник (10 сторінок), Посібник (9 сторінок), Посібник (9 сторінок), Посібник (10 сторінок), Посібник з монтажу (24 сторінок), Посібник (12 сторінок), Посібник (8 сторінок)

Cable Routing Procedures for Dell™ PowerEdge™ R515 Systems

Introduction

This white paper covers recommended cable routing procedures for the Dell™ PowerEdge™ R515

system in the following racks:



PowerEdge™ 2410



PowerEdge™ 4210



PowerEdge™ 2420



PowerEdge™ 4220 (including wide and deep versions)



PowerEdge™ 4820 (including wide and deep versions)

If you are using the optional CMA, following these procedures will allow you to extend the system

from the rack for service without powering down or disconnecting the cables. If you are not using the

CMA, following these procedures will ensure secure attachment and strain relief of the cables behind

the system. For guidelines on how to route cables within the rack, refer to the Dell

Guide for Rack Enclosure

Section 1: Cabling a Dell™ PowerEdge™ R515 With a Cable Management

Arm (CMA)

This section details how to cable a PowerEdge™ R515 system using a CMA. If you are cabling the

system without the optional CMA, refer to Section 2.

Follow the instructions contained in the

the rack. Once installed, use these instructions to install the cables. All illustrations in the following

sections were created using a PowerEdge™ R515 system.

NOTE: PowerEdge™ R515 systems are compatible with the PowerEdge™ R510 rails and CMAs.

Attach the CMA tray to the back of the rails as described in the

in the CMA kit. Connect all applicable cables to the rear of the system and verify that all connections

are secure. See Figure 1.

white paper.

Rack Installation Guide

Best Practices

in the rail kit to install the server into

CMA Installation Instructions

provided

Page 2