Dell POWEREDGE 4300 Посібник з оновлення - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з оновлення для Сервер Dell POWEREDGE 4300. Dell POWEREDGE 4300 23 сторінки. System board upgrade
Також для Dell POWEREDGE 4300: Інформація про встановлення (6 сторінок), Посібник з монтажу (28 сторінок), Встановлення в стійку (37 сторінок), Посібник з встановлення оновлення (14 сторінок), Встановлення в стійку (34 сторінок), Посібник з оновлення (24 сторінок), Інструкція з монтажу Посібник з монтажу (12 сторінок), Посібник із заміни (3 сторінок), Інформація про встановлення (6 сторінок), Посібник з монтажу (14 сторінок)

support.dell.com

Remove and replace the guide brackets.

See "Removing and Replacing the Guide Brackets", found later in this

document.

Remove the cooling shroud.

See "Removing and Replacing the Cooling Shroud", found later in this

document.

Install the upgrade microprocessor.

See "Installing the Upgrade Microprocessors", found later in this document.

Replace the cooling shroud.

See "Removing and Replacing the Cooling Shroud", found later in this

document.

If the upgrade kit comes with a new cooling shroud, you must install the new

cooling shroud. See "Installing a New Cooling Shroud", found later in this

document.

Reassemble and check the system, as follows:

Rotate the power supply back into position, making sure that the securing

tab snaps into place.

Replace the covers and front bezel. Reconnect your computer and peripher-

als to their power sources and turn them on.

As the system boots, it detects the presence of the new microprocessor

and automatically changes the system configuration information in the Sys-

tem Setup program.

NOTE: After you remove and replace the cover of a PowerEdge 1300 system,

the chassis intrusion detector causes the following message to be displayed at

the next system start-up:

ALERT! Cover was previously removed.

Enter the System Setup program and confirm that the top line in the system

data area correctly identifies the installed microprocessor(s). By default, the

serial numbers of Pentium III microprocessors are not displayed. See the

procedures in "Using the System Setup Program" in your User's Guide for

accessing and modifying entries in the System Setup screens.

Reset the chassis intrusion detector while in the System Setup program by

changing Chassis Intrusion to Not Detected.

NOTE: If a setup password has been assigned by someone else, contact your

network administrator for information on resetting the chassis intrusion detector.

Dell PowerEdge Systems — Microprocessor Upgrade

1-5