Dell PowerEdge 4x00 Series Посібник з монтажу - Сторінка 21
Переглянути онлайн або завантажити pdf Посібник з монтажу для Сервер Dell PowerEdge 4x00 Series. Dell PowerEdge 4x00 Series 28 сторінок. Rack installation guide
Також для Dell PowerEdge 4x00 Series: Встановлення в стійку (37 сторінок), Посібник користувача (42 сторінок), Встановлення в стійку (34 сторінок), Посібник з монтажу (37 сторінок)
support.dell.com
front bezel
clips (3)
Figure 1-13. Removing the Front Bezel
Reorienting Drives
Because you changed the orientation of your system from a rack configuration to an
upright tower configuration, you should reorient the drives, including the CD-ROM
drive, in the drive bays so that the drives are still horizontal.
To reorient the drives, perform these steps:
1.
Remove the front-panel inserts from the front bezel.
See your system's Installation and Troubleshooting Guide for instructions on
removing and replacing front-panel inserts.
2.
Reposition the plastic frame surrounding the drive opening in the front bezel:
a.
Facing the inside of the front bezel, press against the center of the frame
with your thumbs until the frame bows sufficiently to loosen the tabs on the
sides of the insert. Pull the frame out of the bezel.
b.
Rotate the frame 90 degrees to match the new orientation of the drives.
c.
Replace the frame in the front bezel and carefully press it into place.
Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide
system
badge
tabs (4)
1-15