Dell PowerEdge 800 Посібник з інсталяції - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з інсталяції для Сервер Dell PowerEdge 800. Dell PowerEdge 800 28 сторінок. Information update - dell openmanage server support kit version 4.3 (.pdf)
Також для Dell PowerEdge 800: Оновлення документації (2 сторінок)

Друкувати сторінку

Insert the card-edge connector firmly into the system-board card connector until the card

is fully seated.

NOTE:

Some systems use a plastic bar to secure the expansion-card bracket to the back panel

instead of a screw.

Install the screw that secures the expansion-card bracket to the back panel.

Close the system. See "Closing the System" in the Installation and Troubleshooting Guide for

instructions.

Figure 1. Installing the DRAC 4/P Card

DRAC 4/P card

card-interface

connector

interface cable

RAC connector

Connect the monitor cable to the card video connector on the DRAC 4/P card. See Figure 2.

The monitor cable must be connected to the card video connector on the DRAC 4/P card—

not to the system's integrated video connector.

Connect the network to the card NIC connector on the DRAC 4/P card. See Figure 2.

The network cable must be connected to the card NIC connector on the DRAC 4/P card—

not to the system's integrated NIC connector.

Reattach the system to its AC power source and turn on the system.

expansion-card bracket

The connectors on your system board and the actual

expansion slot that you use may vary on your system board.

screw

card-edge

connector

system-

board card

connector

expansion

slot