Dell PowerEdge 860 Посібник з експлуатації - Сторінка 35

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Сервер Dell PowerEdge 860. Dell PowerEdge 860 37 сторінок. Sas/raid controller installation
Також для Dell PowerEdge 860: Інформаційне оновлення (14 сторінок), Посібник з інсталяції (28 сторінок), Інструкція з монтажу Посібник з монтажу (7 сторінок)

system board screw (2)

speaker connector

14. Lift the system board at an angle towards the side of the computer and out of the computer base.

Replacing the System Board

CAUTION:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

1. Follow all of the steps in

Removing the System Board

NOTICE:

Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may

result in damage to the computer.

2. Slide the battery into the battery bay, until it clicks in place.

3. Turn on the computer.

NOTE:

After you have replaced the system board, enter the computer Service Tag into the BIOS of the replacement system board.

4. Insert the CD that accompanied the replacement system board into the appropriate drive. Follow the instructions that appear on the screen.

Back to Contents Page

DC-In connector

RJ-11 connector

in reverse order.