DH Lifelabs Sciaire Pro Ceiling Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Газонна та садова техніка DH Lifelabs Sciaire Pro Ceiling. DH Lifelabs Sciaire Pro Ceiling 10 сторінок.

Друкувати сторінку

Installation

WARNING: Shut off the power at the circuit breaker or fuse panel before installation.

If you are unfamiliar with electrical installations, we recommend you contact a qualified

electrician to do the installation.

NOTE: Two people are recommended for installation of this device.

NOTE: MOUNT THIS DEVICE AT LEAST 90.55 INCHES (2.3 M) ABOVE THE FLOOR.

CAUTION: Installer is responsible to ensure grid location is rated for device's weight

prior to installation. If uncertain, use cable to support device from the retention clips

to a suitable support structure. Failure to do so can cause serious injury.

NOTE: FOR USE IN NON-FIRE-RATED INSTALLATIONS ONLY.

Making Electrical Connections

NOTE: The device must be hard wired. All wiring must comply with applicable electrical

codes and ordinances.

Carefully place the device face down.

Remove the driver box cover plate and punch out the knock out hole.

Feed the conduit or Romex (based on local electrical code) through the knock

out hole. NOTE: A lead that is intended to be spliced in the field to a branch-

circuit conductor shall not be smaller than 18AWG (0.82mm2) and the insulation,

if rubber or thermoplastic, shall not be less than 1/32 inch (0.79mm) thick.

Make the electrical connections:

Connect black (L) wire with black wire in the driver.

Connect white (N) wire with white wire in the driver.

Connect ground wire with green wire in the driver.

If a 0-10v dimming circuit is available, connect purple wire to driver DIM+ and

pink wire to driver DIM-.

NOTE: Black wire and White wire are the power carries. The short set is for

the disinfection function connection, while the long set is for the lighting function

connection (only available for the Sciaire Pro Ceiling Light).

Tuck wires inside the driver box and reattach the driver cover.

Optimal Installation Location

Note: Locate and install the device such that it can be easily accessed and opened for

periodic filter replacement.

- It is best to install the device in the center of the room, so that contaminated air is

drawn into the bottom of the device and clean air is evenly discharged from the sides.

This dynamic creates a circular flow pattern, referred to as Coanda Flow.

- The device is designed to be installed in place of a standard 2'x4' ceiling tile, and it

must be securely attached to the building structure for adequate support.

- Depending on the type of building structure, whether the ceiling has an I-Beam or

concrete construction, follow the appropriate protocol for proper installation and

support of the device.

Grid Ceiling Installation

Bend each of the mounting clips on the back of the device upward and then twist

the top 90°.

Place the device into the ceiling grid, hook the mounting clips over the grid

ceiling supports and make sure it is secure.

Suspension Mounting

Depending on mounting location, install 8 toggle bolts into drywall or 8 hook

screws into wood.

NOTICE: Toggle bolts are not considered an acceptable means of support in

Canada, in accordance with CSA C22.2 No. 250.4.

NOTICE: There are many installation applications to suspension mount the

device. Installer is responsible to ensure mounting accessories and hardware are

compatible with attachment method to surface or structure in accordance with

any local code requirements for installation and inspection.