Dell Precision R5400 Посібник - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник для Сервер Dell Precision R5400. Dell Precision R5400 25 сторінок. Technical guide
Також для Dell Precision R5400: Технічні характеристики (2 сторінок), Брошура (2 сторінок), Посібник (13 сторінок), Технічний посібник (36 сторінок)
PCoIP Technology User Guide (Vol I)
Network Webpage
Figure 4: Network Webpage
The Network webpage has 8 parameters:
IP Address Fields
• Enable DHCP (see DHCP vs. Static IP above)
• IP Address (endpoint IP address must be
entered for static IP addressing)
• Subnet Mask (subnet mask for endpoint must
be entered for static IP addressing)
• Gateway (gateway must be entered for static
IP addressing)
• Primary DNS Server (provided by DHCP
server when DHCP is enabled)
• Secondary DNS Server (provided by DHCP
server when DHCP is enabled)
When using static IP addressing, the IP address
fields can be used to specify the IP address on
the Host or Portal endpoints on the network.
When DHCP is used, these fields will be
populated via the DHCP server.
Every endpoint must have a unique IP address
that will not conflict with other equipment on the
network. To simplify configuration, it is
recommended to keep all endpoints on the
same subnet, e.g. 192.168.1.x and a Subnet
Mask of 255.255.255.0.
© 2008 Teradici Corporation
TER0806003 Issue 1
Ethernet Mode
• Auto (recommended – link will auto negotiate
to proper network data rate)
• 10 Mbps Full-Duplex (use when network
equipment, e.g. IP switch, can only support
10Mbps links)
• 100 Mbps Full-Duplex (use when network
equipment, e.g. IP switch, can only support
100Mbps links)
Note: Improper configuration of the Ethernet
Mode may result in a Half-Duplex link. PCoIP
Technology is not compatible with Half-Duplex
operation; a warning overlay will be shown on
Portal display and the session will eventually be
lost.
Maximum MTU Size
• See Maximum Transmission Unit in Section 5,
Network Considerations)
Session Webpage
Figure 5: Session Webpage
The Session webpage has 7 parameters:
General session parameters:
• Accept Any Peer (allows Host to accept any
Portal for PCoIP Session)
• Session Type (PCoIP vs. RDP)
Page 8 of 25