Dell V570 Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Сервер Dell V570. Dell V570 35 сторінок.
Також для Dell V570: Посібник користувача (37 сторінок), Посібник користувача (35 сторінок)
Друкувати сторінку
Power indicator
Condition
codes
Blinking green and
When hot-plugging a PSU, it blinks green five times at a rate of 4 Hz and turns off. This indicates a
turns off
PSU mismatch due to efficiency, feature set, health status, or supported voltage.
If two PSUs are installed, verify that:
● Both PSUs have the same type of label. For example, Extended Power Performance (EPP) label.
● The PSUs are of the same type and have the same maximum output power.
Do not mix PSUs from previous generations of servers, even if the PSUs have the same power rating.
This results in a PSU mismatch condition or failure to turn the VxRail on.
When correcting a PSU mismatch, replace the PSU with the blinking indicator. Do not swap the PSU
to make a matched pair.
To change from a high output configuration to a low output configuration or conversely, you must
power off the system.
AC PSUs support both 240 V and 120 V input voltages except for Titanium PSUs, which support only
240 V.
The following figure shows the DC PSU status indicator:
1. DC PSU status indicator
The following table describes the DC PSU status indicator codes and the related condition of the PSU:
Power indicator
Condition
codes
Green
A valid power source is connected to the PSU and the PSU is operational.
Blinking amber
Indicates a problem with the PSU.
Not illuminated
Power is not connected to the PSU.
Blinking green
When hot-plugging a PSU, it blinks green five times at a rate of 4 Hz and turns off. This indicates a
PSU mismatch due to efficiency, feature set, health status, or supported voltage.
If two PSUs are installed, verify that:
16
VxRail overview
CAUTION:
Mixed PSUs may cause a PSU mismatch condition or failure to power on the
system.
CAUTION:
If the PSU is swapped, an erroneous condition may occur and cause an
unexpected system shutdown.
CAUTION:
When two identical PSUs receive different input voltages, they can output
different wattages and trigger a mismatch.
CAUTION:
Do not combine AC and DC PSUs. It is not supported and triggers a mismatch.